Woofer

May also be supplied with a slightly brown-grey cone

When replacing the upper woofer on a Beolab 6002, the thermistor module must be transferred from the outgoing part

Physically the same driver and enclosure as the woofer for the Beolab 3500, but with different spade connector pins.

Part numbers: 8480248, 8480232

Compatible models:
Beolab 6000, BeoLab 6002

Compatible product type numbers:
6821, 6822, 6823, 6824, 6825, 6832, 6833

Difficulty: slightly fiddly (~10-20 minutes)

Tools required: T10 driver, spudger

Remove all plugs and slide the fret upwards to remove. Undo the four T10 screws attaching the affected woofer.

With the spudger, lift the driver firmly to overcome the adhesive gasket holding it in place.

Release the spring clips retaining the two or four spade connectors, and install the new the woofer

When re-installing the fret, place it against about 1cm from the base, and slide into position while pushing both sides